BC Band Solid State AM Transmitter
Below is the schematic of a crystal controlled two-transistor AM BC Band
transmitter. The final stage is collector modulated using a transistor
audio output transformer as a modulation transformer, driven by an LM386 audio
IC. The oscillator being crystal controlled, the stability is good. Finding
a crystal in the broadcast band my be the hardest part of building this
unit. I found a source of 1000 kHz crystals at a local electronics surplus
store. Luckly, there is no local station on that frequency, so interference
hasn't been a problem.
The circuit can easily be constructed breadboard style on perf board, which is
the way I first constructed it. I later made a printed circuit board using
a pc board kit that comes with rub-on pc patterns, and then the board is
etched using ferric chloride etchant. The transistors were soldered directly
to the circuit, however an 8-pin socket was installed for the LM386 IC.
The audio input can be any high-impedance source such as the output from
a tape deck, but will also work from the output of a cassette recorder.
The power source can be either a 9 or 12 VDC 300 Ma wall plug-in adapter.
Disclaimer:
I have not had the opportunity to check the output of this unit on a spectrum
analyzer for harmonic levels or spurious signals. I did have a
friend who lives less than 1/2 mile away, check for harmonics using a high-grade
communications receiver with a long wire antenna, and he was not able to hear
any signal. The builder and user of this circuit assumes all responsibility
for any interference to any other radio service it may cause, as I make no
claim or guarantees. I would suggest try operating the unit on 9 volts, to
keep the output low and using as short an antenna as possible that will still
give the coverage you desire, however the unit can be operated at 12 volts.
Parts List
Xtal - crystal (BC band)
L1 - 1 mh rf choke
Mouser 434-1100 or equivalent
L2 - 55 uh choke
Mouser 542-4629
L3 - Approximately 20 turns of small magnet wire wound over L2.
After winding the coil, I melted candle wax over it to hold it in place.
T1 - 200 mw transistor output transformer (500 ohm to 16 ohm)
Mouser 42TM026
40-500 pf trimmer - I used part no. C-VT500 from Antique Electronics Supply,
however I noticed in their latest catalogue they no longer list it, and I
don't off hand have another source.
The only tune-up is to adjust the 40-500 pf trimmer for max output. This is
best done by observing the output on a scope, otherwise, tune the signal in
on a radio and tune for best sound. I found that certain settings seemed to
sometimes cause oscillations of the final stage which could be heard as
hash in the receiver.
Adjust the audio gain pot for good modulation without distortion.
Note: If a frequency is chosen toward the lower end of the BC band,
extra capacitance (Cx) may need to be added to lower the frequency of the final
tank circuit. Try 50 to 100 pf or so. You may have to experiment here.
This page has been viewed 1121
times since March 19, 1997.
Return to home page