|
Post a reply/new
message
Topic: Use of desert sand in the transport and erection of the large Egyptian obelisks
Started by Bill Spry on 11/6/01, 8:56 PM
|
Subject |
Use of desert sand in the transport and erection of the large Egyptian obelisks |
Name |
Bill Spry ([email protected]) | Writen | 11/6/01, 8:56 PM |
I am writing in the hope that someone may be able to assist me in learning about the properties of desert sand near Aswan Egypt. %09In studying material about the large obelisks of ancient Egypt I have noticed a clear relationship between the weight of each of the nine existing large obelisks (including the unfinished obelisk at Aswan), the dimensions of each of their bases, and the horizontal force exerted by a pile of just one type of desert sand when piled against the obelisk's base. This is when the obelisk is horizontal and the base is a nearly vertical surface (prior to its erection). This horizontal force is large enough to have been used to "push" each obelisk during the transport and erection process. An initial draft of this work has been published in the Educational Resources Informational Center in the United Stataes with document identification "ED 438 175". %09If this relationship is correct it implies that the ancient Egyptian engineers had much greater sophistication about the use of sand as a working tool than has been realized to the present time. Since all of the large Egyptian obelisks were quarried at Aswan, I am hoping to confirm this relationship of the computed sand type with the actual properties of desert sand found near the quarries. In particular I understand that sand blown from the desert is found on the west bank of the Nile at this location. The two properties of importance are the uncompacted density and the natural angle of repose. %09Can you possibly assist me in determining these two parameters or in obtaining a sample of sand that I might have shipped to my home for measurement? I would very much appreciate hearing your thoughts on this matter. Sincerely yours, Dr. William J. Spry [email protected]
|