Parachutes
employed by the Fallschirmjäger during the
Second
World War
Photographs
reproduced with the kind permission of Hardy Huber

Parachute being prepared
at Wittstock. Meticulous care and attention was taken whilst carrying out
this task. "We were all taught to pack our own chutes and we worked
in teams of two, the chutes were made of silk. We worked each side of a
very long table that the chute was laid on. If the chute did not open,
we always joked that you could go back, make a complaint and get another
one" - Bob Frettlöhr.
In the
thirties General Student had achieved a great organisational feat by laying
the foundations of the German Fallschirmtruppe, but they were still without
their most basic piece of equipment, the parachute.
Tests
were carried out in the mid thirties at the Luftwaffe test centre at Stendal
and the result was the RZ1(Rückenfallschirm Zwangsauslösung
1) parachute, which was loosely based on a civil aviation design.
This parachute was first used at the beginning of the war and was an automatically
deployed parachute by means of a static line which was attached to a wire
cable on the inside of the transport aircraft.
The
RZ1 had a half globe canopy made from white silk and consisted of 28 sections
with a surface area of 56 square metres. The canopy consisted of three
parts, the apex, canopy panels and skirt. Attached to the skirt were the
shroud lines, which met at a central point where they were joined to two
carry lines, which in turn were attached to the parachute harness by means
of two snap hooks.
The
canopy was packed apex first into the deployment bag, which was then placed
into the parachute outer cover with the apex nearest the top. The static
line was attached to this end of the bag. The shroud lines were then packed
vertically on top of the deployment bag. Four flaps on the outside of the
cover were then secured with a securing pin, which was also attached to
the static line.
The
parachute pack cover was attached to the harness D rings with heavy string.
The two carry lines at the bottom of the pack were secured to two larger
D rings on the waist of the harness with the snap hooks. The RZ1 tended
to swing badly in windy conditions and it had a high drop rate, the wearer
could not reach the shroud lines which made it difficult to control and
increased scattering on the ground.

This is a picture of a Fallschirm-Prüfschein,
or parachute test certificate. Every parachute had one of these oilcloth
documents, which recorded every time the chute was packed and by whom.
It was kept in a small flapped pouch on the parachute itself.
Early
tests also showed that the static line sometimes fouled the canopy on opening.
The static line problem was solved with the improved version of the RZ1,
called the RZ16, which replaced it in early 1940. The RZ16 static line
was stowed side to side on top of the contents of the parachute pack. This
outer cover was also stitched to the harness instead of being attached
with string. The RZ16 canopy bag was fitted with external loops for the
stowing of the shroud lines. The harness still retained the two slide release
buckles and snap hooks on the legs.
The carry lines attached
at the waist and gave the jumper no control during descent. As you can
see, this Fj is suspended at an angle as he comes in to land.
The RZ1
& RZ16 although safe for the wearer were difficult to remove on landing.
The RZ20 was similar to the RZ16 parachute but the new harness was fitted
with 4 quick release buckles which enabled the parachutist to clamber free
of his chute quickly and more easily than before, most welcome when landing
under fire or caught in a ground wind. Men trying to struggle free of parachute
harnesses became easy targets. It was first used in the battle for Crete
in May 1941 and continued in service until the end of the war. The number
of canopy panels were reduced in this variant from 28 to 20.
Parachute
colourings were also improved at this time, until now the main colour was
white, which showed up to easily on the ground and acted as a beacon. Crete
saw the use of camouflage-patterned canopy’s as well as white. Officers
were distinguished by white capped canopy’s for easy recognition. At the
time the camouflage canopies were introduced a rumour spread amongst the
men that the chemicals in the dye's used to colour the cutes effected the
smooth opening of the chute itself.
Another
variant was designed called the RZ36, which was triangular in shape and
based on a Russian design. It offered less of a shock to the wearer upon
opening, less swinging motion during the drop and a softer landing. Its
designer sought after a patent but for some reason the military were not
interested in it and it never saw service, although Oberst Baron von der
Heydte used a Russian Triangular parachute for the drop into the Ardennes.
(this may not have been the case after all and it was used in limited numbers
during the ardennes operation, information uncovered by Willi Zahn)
1944
saw the introduction of another design of parachute of the ribbon design,
which was supposed to give better control, but saw limited service.
Special
cargo parachutes were also designed to enable heavy equipment to be dropped
to the paratroops. They consisted of 5 parachutes packed into one bag and
were attached to recoilless rifles; anti-tank guns and even motorcycle
combinations.
Parachutes
were also fitted to the Fallschirmjäger's most vital piece of equipment,
the air dropped weapons and supply containers. In the early airborne operations
including Crete, only a few german paratroopers jumped with their personal
weapons, (with the exception of pistols which were carried in the built
in flare pistol holsters stitched into the back of the jump smock, as well
as handgrenades). After Crete, all paratroops were trained to jump
with their weapons to give direct fire upon landing. All weapons from rifles
and smg's to MG34/42's were dropped separately from the men in rectangular
cannisters. They would be dropped simultaneously from the transport aircraft
using the same automatically deployed parachute, which meant a mad scramble
upon landing to reach the weapons before they could become a fighting unit.
Only
glider borne troops could fight straight after landing as they were dropped
with all their equipment. The problem with the containers was the chance
of them falling into enemy hands as so often happened in Crete.
Up
until operation Mercury there were 3 sizes of container, but Crete saw
the standardization of one container, used for all supplies from weapons
and ammunition to medical supplies and rations.
The
containers were marked with their units designation and coloured markings
to show the contents, they could also be fitted with coloured smoke markers
for better recognition
The
box itself was heavily padded on the interior to protect the contents from
the shock of hitting the ground, all contents were secured with leather
straps. Two handles were fitted externally for easy lifting and inside
was fitted a tow bar and a 2 wheel set which could be fitted to the container
and used as a tow. Containers could be towed together in groups and many
photographs taken in Crete show paratroops pulling them with makeshift
slings and even donkeys were appropriated from farms to pull the containers..
The
bottom of the container was fitted with a light metal corregated shock
absorber which helped to protect the cannister on landing, this could be
replaced making the container reusable.
Tests
and research revealed that safe drops could only be made below 400ft with
winds of 14mph or less. This improved the accuracy of the drop and also
reduced the time in the air, therefore keeping the surprise element. A
demonstration jump by the Fallschirm-Lehr battalion showed that 13 well
trained parachutists could exit a JU-52 in 8 seconds. At an altitude of
330 feet and an aircraft speed of 120 miles per hour their dispersal distance
would only be 25 yards between each man. Any jump carried outside of these
parameters would result in the wide scattering of the stick of paratroops
and more time for ground troops to react. The lowest recorded German airdrop
was over Crete when some of the Fallschirmjäger jumped from 250ft.
(which
is a very daunting thought, a 75m jump, 9m of it static line !!)
The
canopy of the parachute was packed into a cloth bag with a thin cord attached
to the apex of the canopy and the other end attached to the mouth of the
cloth bag. The 9 meter static line was also attached to the canopy bag.
A
crucifix jump position was adopted where the parachutist would launch himself
spread-eagled, horizontally out of the aircraft by means of two handles
either side of the exit. This reduced the swinging motion when the canopy
opened and thus reduced the risk of the parachutist getting tangled up
in the shroudlines. On jumping, the nine metre static line which was attached
to a cable in the aircraft, would pay out . When it became taught it pulled
the canopy bag from the chute pack. The bag would be ripped from the folded
canopy and remain attached to the end of the static line flapping behind
the aircraft. The parachutist would freefall whilst the canopy developed
and the shroud lines payed out. The canopy would fully develop then the
wearer would be exposed to the huge jerking effect as the shroudlines finished
paying out. The parachute was designed to fully deploy after only 100ft.
The crucifix jump was not the best position for landing and called for
the parachutist to land on all fours, which resulted in a high proportion
of serious ankle and wrist injuries even when wearing padded protection.

With ankle and knee injuries
very common in training, instructors stood on the ground and shouted instructions
to the pupils as they approached the ground to ensure they did not forget
the drills and injure themselves. Bob Frettlöhr, a Pioneer veteran
had this to say, " We had three quarter length boots that were fastened
at the side, in order to maximise strength, and your ankles were also strapped.
Despite these measures my ankles have since been a weak point and will
sprain easily. We were taught above all, to always keep our feet and knees
together, with the knees bent for impact".
Each paratrooper
was required to pack his own chute with the aid of a helper (servicewomen
packed the chutes of British paratroops), this was good incentive to
make sure the parachute was packed properly and opened correctly. Incidents
involving incorrectly packed chutes did happen with disastrous results.
When not in use the parachutes were normally kept in a Burlap sack fitted
with carrying handles. These bags were often tucked into the smock or harness
on a training jump so the wearer had it about him when he went to re-pack
his chute. For transportation, the parachutes were put in the carry sacks
and placed in metal containers, which were watertight and sealed with 2
fold down metal handles.
Another photo taken at Wittstock
during jump training. The Fallschirmtruppe had several Fallschirmschule
in operation during WW2. The first jumps were made at Stendal in May 1936
and this later became Fallschirmschule I. In April 1939, the school at
Stendal was moved to Wittstock and re-named Fj.Schule II but was moved
back again a year later. Fallschirmschule III was then opened at Braunschweig
followed in 1941 by Fallschirmschule IV at Salzwedel. In 1943, the school
at Stendal was moved to France and split into two training units, one at
Dreux near Paris and one at Lyon, to accomodate the raising of FJD3.u.5
in France.
As the allies advanced
in Europe, so the Fallschirmschule began to close. Firstly the french schools,
then II & III and lastly Fj.Schule.IV late in 1944.